Texas Instruments 3000 WinSX 사용자 설명서

Troubleshooting

Computer comes on

Internal battery pack still too

when turned on but

warm-Wait about 3 more

turns off before boot-

minutes and try agian.

ing.

Computer Power in-

Automatic discharge cycle

dicator light on, Low

not complete-Leave Power

Batt inidcator blink-

switch in On position until

ing, screen blank, and

all indicator lights go out;

computer will not run.

then plug in AC Adapter
after automatic battery dis-
harge cycle completes and
run computer on ac power.

If Power indicator is orange-
press the Fn-F4 (Stndby)
keys to resume operation.
Blinking Low Batt indicator
signals that computer will
shut off in about 1 minute.

None of the above-Contact
your Texas Instruments
reseller

The built-in LCD screen

Screen contrast/brightness

is blank.

controls-Adjust the contrast
and brightness controls on
the right side of the LCD
screen.

Computer set up for external
monitor-Turn computer off,
wait 5 seconds, turn com-
puter on; or use ALTVID com-
mand to switch back to the
LCD (see Chapter 6 of this
manual).

E-2 Troubleshooting