Extron electronic PMK 150 전단

The Extron

®

 PMK 150 Pole Mount Kit is a 

simple solution for mounting Extron devices 
and their external power supplies to a 
projector pole. 
 
The PMK can be installed on a 1½ inch pipe 
within a 4 inch space between the projector 
and the ceiling.
Including the power supply, the  
following devices can be mounted:

one three-inch deep half-rack device, or 

two 3-inch deep quarter rack devices, or

an MPA 401

Figure 1 shows the parts that are included in the kit.

 

The maximum load for the PMK 150 is 5 lbs (2.25 kg).

NOTE: The PMK 150 is to be used only with Extron UL listed products.

 

NOTE: Ensure the finished installation is in accordance with local and national      

building codes, fire and safety codes, UL requirements, and local and 
national electrical codes.

 

To install the PMK 150 (with a device) on a projector pole:

Place the plate on the base of the device and align holes in the plate with 
the mounting holes in the device (see figure 2).

Secure the device to the plate with 4-40 
screws (see note below). 

 

Use only the screws supplied 

with the device to avoid damaging it.

 

When installing the MPA 401 onto 

the PMK 150, install it with  the rear 
panel facing the projector pipe. Allow 
enough space for the connectors on 
the cables to fit without bending the 
cables excessively. If the space for 
this is inadequate, turn the MPA 401 
around and place it on the PMK so the 
front panel of the device is closest to 
the pipe, and then connect the cables.

PMK 150 • Installation Guide

Pipe Clamp

Mounting Plate

(2) Tie Wraps

(2) Hex Bolts

(2) Washers

(2) 4-40 x 3/16"
Screws

Use 2 mounting
holes on opposite
corners.