Avaya Wireless AP-3 사용자 설명서
Configuring the AP using CLI commands
Avaya Wireless AP-3 User’s Guide A-37
Log into the AP using Telnet
The CLI commands can be used to access, configure, and manage the
AP using Telnet. Follow these steps:
AP using Telnet. Follow these steps:
1. Confirm that your computer’s IP address is in the same IP subnet
as the AP.
NOTE:
If you have not previously configured the Access Point’s IP address
and do not have a DHCP server on the network, the Access Point
will default to an IP address of 10.0.0.1.
If you have not previously configured the Access Point’s IP address
and do not have a DHCP server on the network, the Access Point
will default to an IP address of 10.0.0.1.
2. Go to the DOS command prompt on your computer.
3. Type telnet <IP Address of the unit>.
4. Enter the CLI password (default is public).
NOTE:
Avaya recommends changing your default passwords immediately.
To perform this operation using CLI commands, refer to
Avaya recommends changing your default passwords immediately.
To perform this operation using CLI commands, refer to
.