Cisco Systems NPE-225 사용자 설명서

SDRAM—synchronous dynamic random-access memory.

SDRAM-fixed—SDRAM of a fixed size or quantity; can be replaced, but not upgraded.

SFP module—small form-factor pluggable module.

Unified cache—Instruction cache and data cache are combined. For example, a processor may have 
primary cache with separate instruction and data cache memory, but unified secondary cache.

USB—universal serial bus.

To determine the memory configuration of your NPE-G2, use the show version command.

The following example shows an NPE-G2 installed in a Cisco 7206VXR router. 

Router# show version 

 

Cisco IOS Software, 7200 Software (C7200-JS-M), Version 12.4(PC_D.051028) 

 

CISCO DEVELOPMENT TEST VERSION

 

Copyright (c) 1986-2005 by Cisco Systems, Inc.

 

Compiled Fri 28-Oct-05 00:30 by 

ROM: System Bootstrap, Version 12.3(20050910:182137) [xxxx 103], DEVELOPMENT SOFTWARE

 

7448-1 uptime is 2 days, 17 hours, 52 minutes

 

System returned to ROM by power-on

 

System image file is "disk2:c7200p-js-mz" 

Cisco 7206VXR (NPE-G2) processor (revision A) with 917504K/131072K bytes of memory.

 

Processor board ID 32428149

 

MPC7448 CPU at 1660Mhz, Implementation 0, Rev 2.0

 

6 slot VXR midplane, Version 2.8 

Last reset from power-on 

PCI bus mb1 (Slots 1, 3 and 5) has a capacity of 600 bandwidth points.

 

Current configuration on bus mb1 has a total of 780 bandwidth points. 

 

The set of PA-2FE, PA-POS-2OC3, and I/O-2FE qualify for "half 

 

bandwidth points" consideration, when full bandwidth point counting 

 

results in oversubscription, under the condition that only one of the 

 

two ports is used. With this adjustment, current configuration on bus 

 

mb1 has a total of 480 bandwidth points. 

 

This configuration is within the PCI bus capacity and is supported 

 

under the above condition. 

PCI bus mb2 (Slots 2, 4 and 6) has a capacity of 600 bandwidth points.

 

Current configuration on bus mb2 has a total of 1000 bandwidth points.

 

The set of PA-2FE, PA-POS-2OC3, and I/O-2FE qualify for "half 

 

bandwidth points" consideration, when full bandwidth point counting 

 

results in oversubscription, under the condition that only one of the 

 

two ports is used. With this adjustment, current configuration on bus 

 

mb2 has a total of 800 bandwidth points. 

 

This configuration has oversubscripted the PCI bus and is not a 

 

supported configuration. 

Please refer to the following document "Cisco 7200 Series Port Adaptor

 

Hardware Configuration Guidelines" on Cisco.com <http://www.cisco.com>

 

for c7200 bandwidth points oversubscription and usage guidelines.

 

WARNING: PCI bus mb2 Exceeds 600 bandwidth points 

3 FastEthernet interfaces

 

4 Gigabit Ethernet interfaces

 

2 Packet over SONET interfaces

 

2 Channelized T3 ports