Cisco Systems NPE-225 사용자 설명서
7-9
Network Processing Engine and Network Services Engine Installation and Configuration
OL-4448-12
Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information
Removing the Network Processing Engine
Note
When powering off the router, wait a minimum of 30 seconds before powering it on again.
Step 2
Observe the following items:
•
The green OK LED on the power supply turns off.
•
The fans stop operating.
•
The LEDs on the I/O controller turn off.
•
The LEDs on the port adapters turn off.
Caution
When the power switch on a Cisco uBR7200 series power supply is turned to the off (O) position, the
power supply enters a reset cycle for 90 seconds. Wait at least 90 seconds before turning the power
switch back to the on (|) position. If you do not wait the full 90 seconds, the power supply does not
restart.
power supply enters a reset cycle for 90 seconds. Wait at least 90 seconds before turning the power
switch back to the on (|) position. If you do not wait the full 90 seconds, the power supply does not
restart.
This completes the procedure for powering down the router. The following sections provide instructions
on disconnecting power from the Cisco 7200 VXR routers and Cisco uBR7200 series routers:
on disconnecting power from the Cisco 7200 VXR routers and Cisco uBR7200 series routers:
•
•
•
•
•
Disconnecting AC-Input Power from a Cisco 7200 VXR Router
To disconnect AC-input power from a Cisco 7200 VXR router, complete the following steps:
Step 1
Unplug the input power cable from the power source.
Step 2
Push up on the cable-retention clip that secures the input power cable to the router power supply.
Step 3
Unplug the other end of the input power cable from the power supply. See
.