Cisco Systems Gateway 10 사용자 설명서
7
Figure 2
Verifying Equipment Rack Dimensions
Installing the Chassis Installation Brackets
Each chassis is shipped with two chassis installation brackets in the accessory kit. These brackets are to aid in installing a chassis
into a 19 inch rack and used as a support base to vertically position and set the chassis before the rack-mount screws are
installed.
into a 19 inch rack and used as a support base to vertically position and set the chassis before the rack-mount screws are
installed.
To install the chassis installation brackets into a rack, complete the following steps:
Step 1
Determine where in the rack you want the chassis to be mounted. If you are mounting more than one chassis in the
rack, then start from the bottom up or the center of the rack. Install the chassis installation bracket where the chassis
bottom will be positioned vertically in the rack.
rack, then start from the bottom up or the center of the rack. Install the chassis installation bracket where the chassis
bottom will be positioned vertically in the rack.
Step 2
Secure the chassis installation bracket to the front rails with the rack-mount screws.
Step 3
If there is a second internal rack rail, which is not more than 20 inches from the front rail, you can position the second
installation bracket to act as a rear support for the chassis during installation.
installation bracket to act as a rear support for the chassis during installation.
Figure 3 shows the brackets attached in a rack.
Minimum usable
aperture 17.7 inches
(45.0 cm)
Hole centerline
to hole centerline
18.31 inches ± 0.06 inches
(46.5 cm ± 0.15 cm)
Mounting flanges
28014