Billion Electric Company 30 사용자 설명서
128
Helper: You could also select the application type you would like to apply for
automatic input.
Click Apply to save your changes.
For MAC Address:
automatic input.
Click Apply to save your changes.
For MAC Address:
Source MAC Address: The source MAC Address of the device this rule applies to.
Candidates: You can also select the Candidates which are referred from the ARP
table for automatic input.
Source Port Range: The range of source ports this rule applies to.
Destination Port Range: The range of destination ports this rule applies to.
Helper: You could also select the application type you would like to apply for
automatic input.
4.4.8 Virtual Server
In TCP/IP and UDP networks, a port is a 16-bit number used to identify which
application program (usually a server) incoming connections should be delivered to.
Some ports have numbers that are pre-assigned to them by the Internet Assigned
Numbers Authority (IANA), and these are referred to as "well-known ports". Servers
follow the well-known port assignments so clients can locate them.
If you wish to run a server on your network that can be accessed from the WAN (i.e.
from other machines on the Internet that are outside your local network), or any
application that can accept incoming connections (e.g. peer-to-peer applications)
and are using NAT (Network Address Translation), then you will usually need to
configure your router to forward these incoming connection attempts using specific
application program (usually a server) incoming connections should be delivered to.
Some ports have numbers that are pre-assigned to them by the Internet Assigned
Numbers Authority (IANA), and these are referred to as "well-known ports". Servers
follow the well-known port assignments so clients can locate them.
If you wish to run a server on your network that can be accessed from the WAN (i.e.
from other machines on the Internet that are outside your local network), or any
application that can accept incoming connections (e.g. peer-to-peer applications)
and are using NAT (Network Address Translation), then you will usually need to
configure your router to forward these incoming connection attempts using specific