Toshiba ASD-G9ETH 사용자 설명서
18
ICC
EIP Network Status / Profinet IO Connection Status: When the multi-
protocol firmware image (with EtherNet/IP support) is loaded, this LED
conforms to the prescribed “network status LED” behavior as dictated in the
EtherNet/IP specification, Volume 2, Chapter 9. When the Profinet IO firmware
image is loaded, this LED is on solid green when the controller has established
a link with the interface board and is communicating with it.
Ethernet Activity: Blinks green briefly when network packets are sent or
received.
Heartbeat: Blinks green to indicate communication between the interface card
and the drive. Contact ICC technical support if a blinking red error code is
observed.
protocol firmware image (with EtherNet/IP support) is loaded, this LED
conforms to the prescribed “network status LED” behavior as dictated in the
EtherNet/IP specification, Volume 2, Chapter 9. When the Profinet IO firmware
image is loaded, this LED is on solid green when the controller has established
a link with the interface board and is communicating with it.
Ethernet Activity: Blinks green briefly when network packets are sent or
received.
Heartbeat: Blinks green to indicate communication between the interface card
and the drive. Contact ICC technical support if a blinking red error code is
observed.
6.2 Ethernet Jack
The Ethernet jack also contains two embedded LEDs.
Reserved
Ethernet Link
Ethernet Link: This amber LED is lit whenever a viable Ethernet network is
connected to the port.
Reserved: This green LED is currently unused and is therefore always OFF.