Toshiba ASD-G9ETH 사용자 설명서

 

  

32

ICC 

There are several identification and configuration items available for setting 
various characteristics of the Profinet device.  These items are shown in Figure 
19 and are explained in further detail below. 
 

 

 
A Profinet device’s name (station name) must be unique across the entire 
Profinet network because it is used by controllers to uniquely identify Profinet 
devices.  The Device Name text entry box is used to configure this unique 
device identifier on every drive. 
 
The Update Time field is a configuration item which changes the frequency 
with which command and status data updates take place internally in the 
device.  This setting is not related to the frequency with which data 
communications take place on the Ethernet network.  This time setting is a 32-
bit value adjustable in 1ms increments.  Typically, this value should not need to 
be changed from its default value of 10ms. 
 
 

Whenever any of the Profinet configuration elements (I/O array configuration, 
Device Name, etc.) have been changed, the “submit” button located in the 
lower right-hand portion of the web page must be clicked in order to write these 
settings to the interface card’s filesystem. 
 
Note that because these configuration elements are read from the filesystem 
only when the interface card boots up, the act of submitting configuration 
changes will also reset 
the interface card.  
Please allow 30 
seconds for the 
interface card to reboot, 
at which time it will then 
be operating with the 
recently-submitted 
configuration.  Refer to 
Figure 20.