Toshiba ASD-G9ETH 사용자 설명서

 

  

36

ICC 

Figure 27 shows the check box 
selection that determines whether 
drive configuration parameters 
(registers 1..1000) will be written 
only to the drive’s RAM, or to both 
the drive’s RAM and EEPROM 
when they are changed via the 
interface card. 
 
If written to RAM only, then parameter value changes will be lost when the drive 
is power cycled or otherwise reset.  If written to both RAM and EEPROM, then 
parameter value changes will be retained.  When enabling writes to EEPROM, 
be sure to always observe Toshiba’s restrictions on the number of times a 
configuration parameter may be written to EEPROM before possible EEPROM 
damage occurs. 
 
This selection affects all configuration parameters, and applies regardless of 
the interface card mechanism used to modify the parameters (control protocol 
data write, modification via the web page “monitor” tab, timeout configuration 
setting etc.) 
 
Note that ASD Interface CPU firmware version V1.100 or later is required for 
this feature to be supported (refer to Figure 10 on page 26 for how to determine 
the ASD interface CPU version.) 
 
 

Figure 28 shows the entry boxes 
used to modify the authentication 
credentials.  The case-sensitive 
username and password can 
contain letters (“a”..”z” and “A”..”Z”) 
and numbers (“0”..”9”), and can 
each be up to 80 characters in 
length. 
 
Be sure to make a note of the new 
settings whenever these credentials 
are changed, as they must be entered whenever the web page is accessed, an 
FTP session is initiated, or when a configuration change is performed via the 
Finder utility.  Contact ICC for assistance if you have forgotten your customized 
credentials.