Panasonic AW-PH360N 사용자 설명서
- 11 -
Installation
(The installation work must be performed by your dealer without fail.)
$
Transmission signal selection setting
The switches on the COMP and CONNECTOR printed circuit boards must be set to
correspond to the signals to be transmitted and components to be connected to the
pan/tilt head.
(When shipped, the analog settings are supported.)
correspond to the signals to be transmitted and components to be connected to the
pan/tilt head.
(When shipped, the analog settings are supported.)
<Note>
O
Before setting the switches, make absolutely sure that the power of the AC adapter
which is to be connected to the pan/tilt head is set to OFF.
which is to be connected to the pan/tilt head is set to OFF.
O
Analog/IEEE1394 card settings
SDI/PR switch:
PR
WEB/1394 switch:
1394
WEB/RP 422 switch: RP 422
O
SDI settings
SDI/PR switch:
SDI
WEB/1394 switch:
1394
WEB/RP 422 switch: RP 422
O
WEB card settings
SDI/PR switch:
PR
WEB/1394 switch:
WEB
WEB/RP 422 switch: WEB
COMP printed circuit board
PB switch
Do not change the setting of this
switch — use it at the PB position.
Do not change the setting of this
switch — use it at the PB position.
COMP switch
SDI/PR switch
CONNECTOR printed circuit board
WEB/1394 switch
WEB/RP 422 switch