Panasonic BL-PA300KTA 사용자 설명서

15

Installation

Refer to the information on page 7 when selecting a location to place your 
adaptors.

•

If you have purchased additional adaptors, make sure you have 
registered them to the master (see page 21) before placing them where 
you plan to use them.

Connect the adaptor to a wall outlet in the room where you plan to use 
it.

Confirm that the PLC indicator of each adaptor lights in green when you 
plug the adaptors into the wall outlets.

•

If the PLC indicators do not light in green, see page 23.

After you have plugged the adaptors into the wall outlets in the rooms where 
you plan to use them, test the terminal’s network speed (see page 17).

If a terminal’s LAN port is inactive for more than 20 minutes (i.e., if its LAN 
indicator is orange for more than 20 minutes), the terminal automatically 
enters Power Save mode, and its power consumption is reduced. While in 
Power Save mode, the adaptor’s LAN indicator is turned off.

Power Save mode is only activated for terminal adaptors that are linked to 
the HD-PLC network.

Power Save is deactivated when:
- An active network device is connected to the terminal.

- A network device connected to the terminal is turned on.
- The adaptor’s SETUP button is pressed.

BL-PA300

PLC

SETUP

LAN MASTER

BL-PA300

PLC

SETUP

LAN MASTER

PLC

Terminal Adaptor

Power Save Mode

about 20 minutes later

LAN

MASTER

PLC

(green)

(green)(orange)

LAN

MASTER

BL-PA300KTA_OI.book  Page 15  Wednesday, August 6, 2008  10:08 AM