Sony STRDG720 사용자 설명서
48
GB
x SB SPK (Surround back
speakers)
When the surround speakers are set to “NO”,
the surround back speakers are also
automatically set to “NO” and the setting
cannot be changed.
• NO
the surround back speakers are also
automatically set to “NO” and the setting
cannot be changed.
• NO
If you have not connected a surround back
speaker, select “NO”.
speaker, select “NO”.
• SINGLE
If you connect only one surround back
speaker, select “SINGLE”. The sound will
be output to a maximum of 6.1 channel.
speaker, select “SINGLE”. The sound will
be output to a maximum of 6.1 channel.
• DUAL
If you connect two surround back speakers,
select “DUAL”. The sound will be output to
a maximum of 7.1 channel.
select “DUAL”. The sound will be output to
a maximum of 7.1 channel.
Tip
The “LARGE” and “SMALL” settings for each
speaker determine whether the internal sound
processor will cut the bass signal from that channel.
When the bass is cut from a channel, the bass
redirection circuitry sends the corresponding bass
frequencies to the sub woofer or other “LARGE”
speakers.
However, since bass sounds have a certain amount
of directionality, it is best not to cut them, if
possible. Therefore, even when using small
speakers, you can set them to “LARGE” if you want
to output the bass frequencies from that speaker. On
the other hand, if you are using a large speaker, but
prefer not to have bass frequencies output from that
speaker, set it to “SMALL”.
If the overall sound level is lower than you prefer,
set all speakers to “LARGE”. If there is not enough
bass, you can use the equalizer to boost the bass
levels. For details, see page 38.
speaker determine whether the internal sound
processor will cut the bass signal from that channel.
When the bass is cut from a channel, the bass
redirection circuitry sends the corresponding bass
frequencies to the sub woofer or other “LARGE”
speakers.
However, since bass sounds have a certain amount
of directionality, it is best not to cut them, if
possible. Therefore, even when using small
speakers, you can set them to “LARGE” if you want
to output the bass frequencies from that speaker. On
the other hand, if you are using a large speaker, but
prefer not to have bass frequencies output from that
speaker, set it to “SMALL”.
If the overall sound level is lower than you prefer,
set all speakers to “LARGE”. If there is not enough
bass, you can use the equalizer to boost the bass
levels. For details, see page 38.
x FRT DIST. (Front speaker
distance)
Lets you set the distance from your listening
position to the front speakers (A).
If both front speakers are not placed an equal
distance from your listening position, set the
distance to the closest speaker.
position to the front speakers (A).
If both front speakers are not placed an equal
distance from your listening position, set the
distance to the closest speaker.
With only one surround back
speaker
speaker
With two surround back speakers
(The angle B should be the same)
(The angle B should be the same)
x CNT DIST. (Center speaker
distance)
Lets you set the distance from your listening
position to the center speaker.
position to the center speaker.
x SL DIST. (Surround left speaker
distance)
x SR DIST. (Surround right
speaker distance)
Lets you set the distance from your listening
position to the surround speakers.
position to the surround speakers.
x SB DIST. (Surround back
speaker distance)
a)
x SBL DIST. (Surround back left
speaker distance)
b)