Texas Instruments TMS320TCI648x 사용자 설명서
www.ti.com
5.2
Peripheral Identification Register (PID)
SRIO Registers
The peripheral identification register (PID) is a read-only register that contains the ID and ID revision
number for that peripheral. The PID stores version information used to identify the peripheral. Writes have
no effect to this register. The values are hard coded and will not change from their reset state.
number for that peripheral. The PID stores version information used to identify the peripheral. Writes have
no effect to this register. The values are hard coded and will not change from their reset state.
The peripheral ID register (PID) is shown in
and described in
Figure 63. Peripheral ID Register (PID) - Address Offset 0000h
31
24 23
16
Reserved
TYPE
R-00h
R-01h
15
8 7
0
CLASS
REV
R-0Ah
R-01h
LEGEND: R/W = Read/Write; R = Read only; -n = Value after reset
Table 41. Peripheral ID Register (PID) Field Descriptions
Bit
Field
Value
Description
31–24
Reserved
Reserved
23–16
TYPE
Peripheral type: Identifies the type of the peripheral RIO
15–8
CLASS
Peripheral class: Identifies the class Switch Fabric
7–0
REV
Peripheral revision: Identifies the revision of the peripheral. This value should begin at 01h and be
incremented each time the design is revised .
incremented each time the design is revised .
SPRUE13A – September 2006
Serial RapidIO (SRIO)
111