Netgear WG302v2 사용자 설명서

Basic Installation and Configuration

2-3

The time it takes to establish a wireless connection can vary depending on both your security 
settings and placement. 

Before you install the Wireless Access Point, make sure that your Ethernet network is up and 
working. You will be connecting the access point to the Ethernet network. Then computers with 
802.11b/g wireless adapters will be able to communicate with the Ethernet network. In order for 
this to work correctly, verify that you have met all of the network and system requirements 
described in 

To set up and install your WG302v2 Wireless Access Point:

1. Set up the WG302v2.

a. Prepare a computer with an Ethernet adapter. If this computer is already part of your 

network, record its TCP/IP configuration settings. 

b. Configure the computer with a static IP address of 192.168.0.210 and 255.255.255.0 for 

the Subnet Mask.

Connect an Ethernet cable from the WG302v2 to the computer.

d. Connect the power adapter to the WG302v2 and verify the following:

–

The PWR power light goes on. 

–

The LAN light of the wireless access point is lit when connected to a powered on 
computer.

2. Configure LAN and wireless access. 

a. Use your Web browser to connect to the WG302v2.

Note: To view a list of the factory default settings, see 

Tip: Before mounting the WG302v2 in a high location, first set up and test the 

WG302v2 to verify wireless network connectivity.