Netgear SC101T 전단

)NSTALLATION

Estimated Completion Time: 30 minutes.

After you prepare for installation, these instructions will guide you through these three 
steps:

1.

Install a hard disk, and connect the Storage Central SC101T to your network.

2.

Install the Storage Central SC101T software.

3.

Allocate SC101T disk space for each PC that will use the SC101T.

When you finish the installation, your network will resemble this illustration.

•

You must have an SATA hard disk, an Ethernet network with an available port, DHCP 
must be running in the network, and you need to have either Windows XP (SP2) or 
Windows 2000 (SP4) PCs to access the SC101T.

•

Unpack the unit, Ethernet cable, power adapter, and the NETGEAR CD. The CD 
contains driver software, a setup wizard, and links to online resources. Familiarize 
yourself with the Storage Central SC101T unit. The back panel of the SC101T has 
information about the ports and the status lights located on the front panel.

•

When you set up the unit, stand it on its feet, and be sure it has ample ventilation. 
Avoid putting the unit in a location where it could be knocked over easily. Do not 
place items on top of it.

Warning: Be sure the SC101T power cord is 
unplugged before adding or removing the disks. 
Failure to observe this precaution could render your 
disks useless.

The instructions below explain how to set up a single 
disk. Repeat these steps to install a second disk.

1.

Remove the front cover.

2.

Insert a hard disk.

•

Position the disk with the bottom 
facing in.

•

Slide the disk into either slot.

•

Replace the front cover

3.

Connect the SC101T to your network.

Connect the provided Ethernet cable to your network 
and to the back of the SC101T. Be sure your network 
is running. DHCP must be available in the network. 
DHCP is usually enabled on home networks by 
default.

4.

Turn on the SC101T

Plug in the power adapter to a power source 
and connect the other end to the SC101T. Turn 
the unit on. View the front panel to verify that 
the green power light is on and that the green 
network light is on.

Note: This software must be installed on each PC that will access the 
Storage Central Node.

1.

Insert the NETGEAR CD into your PC. If this screen does not 
appear, run Autorun.exe on the CD. Click Install Software.

2.

Click Check for Updates and proceed according to the prompts. The software checks 
to see if the SC101T is on your network. You can install the software even if the unit 
is not yet on your network. If Windows logo certification warnings appear, click 
Continue to proceed.

3.

Follow the New Hardware Found prompts to 
complete the installation of several software driver 
components. You will see the Storage Central 
Manager utility icon on your desktop.

4.

Run the Storage Central Manager, which can 
check for updates. Click Next to proceed, and. 
follow the prompts to check for and install 
additional product updates.

After the additional product updates process 
completes, you will see the Storage Central 
Manager configuration mode selection screen.