Netgear GA511 전단

)NSTALLATION

Please refer to the Reference Manual on your CD for instructions on advanced 
configuration options.
Estimated Completion Time: 15 minutes.

Before installing the GA511, please make sure that your computer meets the following 
minimum system requirements: 

•

A notebook PC with a Pentium

®

 300 MHz or higher compatible processor with an 

available CardBus slot

•

A CD-ROM drive

•

64 MB of memory

•

At least 5 MB of disk space

•

Windows XP Home, Windows XP Professional, 2000, Me, 98SE (2nd edition), 
Windows 2000 Professional, Windows 2000 Server, or Windows 2000 Advanced 
Server. Some versions of Windows may ask for the Windows operating system 
installation files to complete the installation of the GA511 driver software.

a.

Power on your notebook, let the operating system boot up completely, and log in 
as needed. 

b. Insert the NETGEAR Adapter Resource CD into your CD-ROM drive. The 

Adapter Resource CD main page will load.

c.

From the Windows Start menu, select Run. The Run dialog box opens.

d. Enter the path to the GA511 setup.exe file on the CD. For example, if your 

CD-ROM is drive D, enter D:\GA511\setup as the path. Then, click OK.

e.

Follow the InstallShield Wizard steps. Click Finish when done. Remove the 
NETGEAR Adapter Resource CD. If prompted, restart your computer.

Now, the GA511 driver and utility software are installed.

a.

Locate an available CardBus slot on the side of your notebook. Hold the PC Card 
with the NETGEAR logo facing up and insert it into the CardBus slot.

Note: Do not use excessive force, but make sure the card is fully inserted into the slot. 
b. Follow the Found New Hardware Wizard steps.

Accept the “Install the software automatically” setting, and click Next to proceed.
Note: If Windows XP or 2000 displays a Windows XP Logo Testing or a Digital 
Signature Not Found warning, click Continue Anyway or Yes to proceed.

c.

Click Finish to complete the installation. If prompted to restart your computer, 
power down and restart the notebook. You will see the GA511 Smart Wizard icon 

in the system tray on the lower right side of the Windows task bar. 

a.

Double-click the connection icon 

 in the Windows system tray to open the 

Windows network connection page.
If the connection icon is not visible, you can change the connection properties by 
going to Start > Control Panel > Network Connections.

b. Double-click on the NETGEAR GA511 Gigabit CardBus Adapter connection.
c.

Click Configure.

d. Click Properties and configure the GA511 according to your network 

requirements.
For assistance with configuring the network settings, please see the networking 
tutorials on the NETGEAR Adapter Resource CD.

a.

Click the GA511 Smart Wizard icon 

on the lower right side of the 

Windows task bar.

b. Verify that the GA511 status information matches your network. 

Note: If you are unable to connect, see the the Troubleshooting section below or the trou-
bleshooting tips in the Reference Manual on the NETGEAR Adapter Resource CD.