Netgear GA311 사용자 설명서
3-1
v1.0, February 2007
Chapter 3
Configuration and Troubleshooting
This chapter describes how to use the advanced configuration options of your NETGEAR 10/100/
1000 Mbps Gigabit Ethernet Adapter GA311 and basic troubleshooting techniques.
1000 Mbps Gigabit Ethernet Adapter GA311 and basic troubleshooting techniques.
Understanding the Configuration Options
The GA311 adapter provides the following advanced options:
•
Configure the 802.1Q VLAN ID. The IEEE 802.1Q standard defines the operation of Virtual
LAN (VLAN) Bridges that permit the definition, operation and administration of Virtual LAN
topologies within a Bridged LAN infrastructure.
LAN (VLAN) Bridges that permit the definition, operation and administration of Virtual LAN
topologies within a Bridged LAN infrastructure.
•
Configure 802.1Q/1p VLAN tagging. The 802.1p Quality of service (QOS) is an OSI layer 2
standard for prioritizing network traffic at the data link sublayer.
standard for prioritizing network traffic at the data link sublayer.
•
Enable Jumbo frames to extend Ethernet frames to 7500 bytes
•
Set the link speed and the duplex mode:
–
Auto Negotiation
–
1000Mbps/Full Duplex
–
100Mbps/Full Duplex
–
100Mbps/Half Duplex
–
10Mbps/Full Duplex
–
10Mbps/Half Duplex
•
Set up checksum offloading to the network card
•
Set up the offload of TCP large packets to the network card
•
Enable wakeup on ARP/PING