Omega Engineering OMG-CONV-485-ISO 사용자 설명서
Installation
OMG-CONV-485-ISO
Page 6
Operating System Installation (For Windows Users)
RS-422/RS-485 Four Wire Master/RS-485 Two Wire Auto
Mode Installation
Mode Installation
If your application is 4-wire Full Duplex RS-422 or 4-Wire RS-485 Master, where
control of the transmitter is not required, or 2-wire RS-485 and you intend to use
the Auto Mode to control the transmitter, simply connect the OMG-CONV-485-
ISO to an existing RS-232 COM: port. This will utilize the Operating System Serial
Driver to control the COM: port. You will want to install the diagnostic utility,
WinSSD, to test and verify proper operation of the port.
control of the transmitter is not required, or 2-wire RS-485 and you intend to use
the Auto Mode to control the transmitter, simply connect the OMG-CONV-485-
ISO to an existing RS-232 COM: port. This will utilize the Operating System Serial
Driver to control the COM: port. You will want to install the diagnostic utility,
WinSSD, to test and verify proper operation of the port.
Start by choosing Install Software at the beginning of the CD. Choose
Asynchronous COM: Port Software, SeaCOM. Continue with the installation
until the “Setup Type” dialog, as shown below, appears. Choose “WinSSD
Utility” to install just the diagnostic tool. A Start Menu Program Group,
“SeaCOM” will be created and WinSSD can be started from there.
Asynchronous COM: Port Software, SeaCOM. Continue with the installation
until the “Setup Type” dialog, as shown below, appears. Choose “WinSSD
Utility” to install just the diagnostic tool. A Start Menu Program Group,
“SeaCOM” will be created and WinSSD can be started from there.