Nortel Networks 703t 사용자 설명서
October 2006
703t server description
703t Server Hardware Installation
19
The table below describes the parts that are identified in the preceding
diagram:
diagram:
Part
Function
Reset button
Triggers a hardware (cold) reset. Do not use
this button to perform a server restart. Restart
the server as described in “Restarting the
server” in the Installation and Configuration
Task List (555-7101-210).
this button to perform a server restart. Restart
the server as described in “Restarting the
server” in the Installation and Configuration
Task List (555-7101-210).
Network
controller LEDs
(green)
controller LEDs
(green)
Left: 10/100Base-T controller LED
(NIC1 10/100 MB: ELAN
for Meridian 1
(NIC1 10/100 MB: ELAN
for Meridian 1
*
/Succession 1000
*
connection)
Right: 10/100/1000Base-T controller LED
(NIC2 1 GB: CLAN
for Customer LAN connection)
(NIC2 1 GB: CLAN
for Customer LAN connection)
Sleep mode button
Not used
Power button
Turns the server’s power on or off.
Status LEDs
Indicates when the server is powered up and
the disk drives are active.
the disk drives are active.
Left: hard drive activity LED (not used)
Center: power/sleep LED (green)
Right: status LED (bi-color) indicates
whether the server is functioning properly,
or whether a hardware event has occurred.
whether the server is functioning properly,
or whether a hardware event has occurred.
USB connector
For future use
Floppy disk eject
button
button
Ejects the floppy disk.
Floppy drive
Drive for 3-1/2 inch diskettes.