Nortel Networks 4050 사용자 설명서
508 Chapter 10 Configuring system settings
320818-A
Configuring host interfaces using the SREM
The default IP interface on the Nortel SNAS 4050 host is Interface 1. You can
create additional interfaces and specify the ports to be assigned to each interface.
If you assign more than one port to an interface, you can choose whether the ports
will operate in failover or trunking mode.
create additional interfaces and specify the ports to be assigned to each interface.
If you assign more than one port to an interface, you can choose whether the ports
will operate in failover or trunking mode.
To view a list of interfaces on a particular Nortel SNAS 4050 host, select the
System > Hosts > host > Interfaces tab, as shown in
System > Hosts > host > Interfaces tab, as shown in
Figure 133
Interfaces
To continue, choose one of the following procedures:
•
•