Delta Electronics none 사용자 설명서

Chapter 2  Installation and Storage|ASDA-AB Series

 

Revision March 2008, Doc. Name: 2007PDD23000011 

 

2-3

 

Incorrect installation may result in a drive malfunction or premature failure of the drive and or motor. Please 

follow the guidelines in this manual when installing the servo drive and motor.  

The ASDA-AB servo drive should be mounted perpendicular to the wall or in the control panel. In order to 

ensure the drive is well ventilated, ensure that the all ventilation holes are not obstructed and sufficient free 

space is given to the servo drive. Do not install the drive in a horizontal position or malfunction and damage 

will occur. 

 

The ASDA-AB Servo drives must be back mounted vertically on a dry and solid surface such as a NEMA 

enclosure. A minimum spacing of two inches must be maintained above and below the drive for ventilation 

and heat dissipation. Additional space may be necessary for wiring and cable connections. Also, as the drive 

conducts heat away via the mounting, the mounting plane or surface should be conductor away and not 

conduct heat into the drive from external sources 

The ECMA Servo motors should be mounted firmly to a dry and solid mounting surface to ensure maximum 

heat transfer for maximum power output and to provide a good ground.  

For the dimensions and weights specifications of servo drive or motor, please refer to Chapter 11 

“Specifications". 

Install a fan to increase ventilation to avoid ambient temperatures that exceed the specification. When 

installing two or more drive adjacent to each other please follow the clearances as shown in the following 

diagram.