LSI Series 520 사용자 설명서
Installation Steps
6-3
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
6.2.1
Step 1: Unpack
Unpack and install the hardware in a static-free environment. Remove
the MegaRAID SCSI 320-1 controller card from the anti-static bag and
inspect it for damage. If the card appears damaged, or if any item listed
below is missing, contact LSI Logic or your MegaRAID OEM support
representative. The MegaRAID SCSI 320-1 controller is shipped with the
following:
the MegaRAID SCSI 320-1 controller card from the anti-static bag and
inspect it for damage. If the card appears damaged, or if any item listed
below is missing, contact LSI Logic or your MegaRAID OEM support
representative. The MegaRAID SCSI 320-1 controller is shipped with the
following:
·
The Driver and Documentation CD, which contains these items:
–
The MegaRAID Configuration Software Guide
–
The MegaRAID Operating System Driver Installation Guide
–
The MegaRAID SCSI 320-1 Hardware Guide
–
The software license agreement
–
The MegaRAID SCSI 320-1 configuration utilities for DOS
·
The warranty registration card
6.2.2
Step 2: Power Down
Turn off the computer, remove the power cord, then remove the cover.
Make sure the computer is turned off and disconnected from any
networks before installing the controller card.
Make sure the computer is turned off and disconnected from any
networks before installing the controller card.
6.2.3
Step 3: Check Jumper Settings
Make sure the jumper settings on the MegaRAID SCSI 320-1 card are
correct. The jumpers are set at the factory and you probably do not need
to change them.
correct. The jumpers are set at the factory and you probably do not need
to change them.
lists the jumpers (and a connector).
Table 6.2
Jumpers for the MegaRAID SCSI 320-1
Item
Description
Type
J2
Dirty cache LED
2-pin header
J3
Clear EPROM
2-pin header
J4
BIOS enable
2-pin header
J5
SCSI activity LED
2-pin connector
J6
Serial port
3-pin header