EIKI MD13NET 사용자 설명서

Use of Serial Port

You can control the equipment connected to the serial port on the network board and
control projector itself by using the telnet application*

1

installed on your computer.

The following is a control example of external equipment. The telnet application is
required to use commands*

2

which control the external equipment.

Turn the projector off with the mains switch and connect an external equipment to
the serial port with an RS-232C serial cable.

Turn the projector and external equipment on.

Display the setting page by clicking on the 

linked text on the main menu

with the web browser. ( refer to page 62).

Change the serial port setting to be the same communication condition as the con-
nected external equipment and then press the 

button.

The following example setting is for our projector
communication condition. When controlling our pro-
jector set as follows

:

(For example, in case of using the Telnet application in the Windows 98.)

Select the 

submenu from the 

menu on the computer. Type “telnet” onto

the 

text area on the displayed window and press the 

button.

Launch the telnet application and the following window will be displayed. Select
the 

from the 

pulldown menu.

*1 For further instructions about the telnet application, please see the on-line guide on your

computer. Macintosh does not provide the telnet application.

*2 The commands are defined by each product independently, so please consult the manufac-

turer or sales dealer for further information of the commands.

Baud rate ..........19200
Parity ................NONE
Stop ..................1
Flow Control ......NONE
Data ..................8
Serial Control ....External
Port ..................23