VIVOTEK IP3111/IP3121 사용자 설명서

 

 
 
 
 
 

www.vivotek.com

 

  

T: 

886-2-22404099 

  

F: 

886-2-22404097 

 

 
 
 
 
 
 

11

 

There is a button hidden in the box for restoring the system factory default settings. When the system fails 

to install or operates abnormally, use the included assistant stick in the package and follow the following 

procedures to reset the system back to its original status. 

 

Poke the assistant stick into the hole to press down on the restore button. Restart the system by 

unplugging and re-plugging the power jack. While keeping the button pressed, the system will perform 

POST twice rather than the usual once, which can be observed from the flashing LEDs. After the system 

flashes the LEDs for the second time, withdraw the stick to release the button. The system will have 

restored factory default settings at that moment. 

 

Connect the power jack of the included power adapter. Connecting the power adapter should be the last 

operation while physically installing NetworKam. 

 

If the auto iris lens is used, AES on rear panel must be turned OFF. And you also have to select VIDEO 

Drive or DC Drive lens by the switch. 

The pin assignment of the auto iris lens connector is as follows: 

 

 

VIDEO Drive  DC Drive 

Pin 1 

Power source  Damp- 

Pin 2 

Video signal 

Damp+ 

Pin 3 

Not used 

Driver+ 

Pin 4 

Ground, Shield  Driver-