Quantum Audio 3A Series 사용자 설명서

Connecting Ethernet and Power Cables

Connecting Ethernet and Power Cables

To connect the Ethernet and power cables to the autoloader, follow these steps:

Attach one end of the Ethernet cable (included in the accessory kit) to the tape drive 

Ethernet port on the back panel of the autoloader.

Attach the other end of the Ethernet cable to your host network port or router.

Attach the female connector of the power cable to the power connector on the back 

panel of the autoloader.

Plug in the power cable to the nearest properly grounded power outlet, then turn on 

the power switch on the back panel of the autoloader.

Turn on the autoloader by setting the power switch on the back panel to the 

 

position and pressing the power switch on the front panel. Check the LCD screen to 

make sure the autoloader is receiving power. If it is not, check the power connections 

and your power source.
During the Power-on Self Test (POST), both LEDs are illuminated briefly, followed by 

only the 

 LED flashing. When the initialization sequence is complete, 

the LCD screen displays the 

 screen.

Whenever you power cycle the autoloader, allow 10 seconds before 

turning the power back on. The power supply requires at least two to 

three seconds for the capacitors to discharge. This ensures a complete 

system reset on power down and may avoid system errors.

The autoloader will not complete the initialization sequence unless both 

tape magazine openings are properly closed. You can use two magazines 

or one magazine and one magazine blank.

When the SuperLoader 3A Series is powered up, it undergoes a media 

inventory. Each tape cartridge in the autoloader is inserted into the 

A-Series tape drive and inventoried. Depending upon the number of 

cartridges in each magazine and the amount of content or data on each 

cartridge, the media cartridge inventory may take up to forty minutes.