Printronix Network Interface Card 사용자 설명서

129

2.

Find the Ethernet address for the NIC by printing a 
configuration or reading it from the control panel. It must be 
entered as part of this procedure.

3.

Use the arp command to add an entry into the Unix station 
ARP table for this NIC. Here is the most common syntax for this 
command:

arp -s ipaddress ethernetaddress

Example for Microsoft TCP stacks:

arp -s 192.75.11.9 00:80:72:07:00:60

This example specifies a NIC using IP address 192.75.11.9 
and Ethernet address 00:80:72:07:00:60.

4.

Verify that the ARP entry was properly applied.

arp -a

You should see an entry in the listed ARP table with the IP 
address and Ethernet address specified in step 3.

5.

Try to ping this IP address to see if the NIC can be seen on 
your network.

At this point, you should be able to communicate with the NIC from 
your local Unix station. This means the printer knows about an IP 
address and subnet mask and has these settings in its current 
memory. However, if the NIC is shut off, these settings will be lost 
unless you store them in flash memory, as follows:

1.

Load a Web browser on your Windows station and direct it to 
the URL:

http://NICIPaddress/networkConf.html

(e.g., http://192.75.11.9/networkConf.html).

NOTE: If prompted for a “User ID” and password first, type in 

 for the ID and press ENTER at the password prompt 

(since there is no default password).

2.

At the “Network Configuration” HTML form that displays, click in 
the field below the “IP Address” heading and type in the IP 
address for the NIC.