Quantum Audio Scalar 50 사용자 설명서

Quantum Scalar 50 Tape Drive Installation Instructions

Document 81-81769-01 B01

September 2007

Completing the Native Fibre Channel Installation

19

•

0

To connect via a Telnet session to a SAN switch:

Connect the service laptop to the SAN switch using an Ethernet cross-

over cable, or by connecting to the LAN (if available).

On the service laptop, open a command prompt window.

From the command prompt, enter the following command and press 
<Enter>

:

telnet <IP address of SAN switch>

The SAN switch login prompt displays.

Enter the 

 and 

 and press <Enter>.

For Brocade switches, at the command prompt, type 

 and press 

<Enter>

.

The nsshow command displays (see 

Figure 21  Nsshow 
Command

The information below applies to a Brocade SAN switch. For other 

SAN switches, contact the SAN administrator.

For Brocade SAN switches, the default login is admin for the 

username and 

 for password. This may have been 

changed by the system administrator. For all other switches, 

contact the system administrator.