Quantum Audio STT3401A 사용자 설명서

Drive operation and maintenance 

Page 18 

Seagate Travan 40 Product Manual 

 

 

After removing the cartridge from the drive, place the cartridge in its protective case 
and store it in a cool, dry location. 

If the drive will not eject a cartridge during normal operation, but you still have power 
to the drive, try the following steps to force the drive to eject the cartridge: 

1.  Remove power from the drive. 

2.  Press and hold the eject button. 

3.  Power up the drive, while holding down the Eject button. The cartridge will be 

ejected (unloaded). 

As soon as the cartridge is unloaded, grasp the cartridge and pull it from the drive. 

If the power fails with a cartridge in the drive, and the procedure above does not 
work, you may be able to remove the cartridge manually. However, there is a risk of 
damaging the drive or the cartridge. 

Note.  Do not attempt to remove the cartridge while the drive is powered-on and 

tape is in motion. This may result in an incomplete tape operation. 

Take a small straight screwdriver and insert it into the notch in the lower left side of 
the bezel below the cartridge. Make sure that the screwdriver is inserted straight into 
the drive. The screwdriver will hit a stop. Push on the stop with a firm force. As the 
stop is gradually pushed into the drive, the cartridge will come out of the drive. 
Continue to push with the screwdriver until the edges of the cartridge can be 
grasped. Then grasp the cartridge and pull it firmly from the drive.