Zhone Technologies 600 사용자 설명서
7-4
Server Cards
Model No.
Running Head
Inverse Multiplexer (IMUX) Card Settings
IMUX Card
BONDING MODE
The Bonding Mode parameter shows the bonding mode used for this call. The values for this
setting are 00 (mode0) and 01 (mode1). The bonding mode is selected from the HSU card
IMUX screen.
setting are 00 (mode0) and 01 (mode1). The bonding mode is selected from the HSU card
IMUX screen.
LAST DISC.
The Last Disconnect parameter shows the cause codes for the last disconnect on that port. The
values are 01 (no resources available), 02 (channel error), 03 (normal clearing), 04 (bandwidth
addition request), 05 (mode not supported), 06 (rate not supported), 07 (information channel
or frame alignment word framing lost), 08 (delay equalization unsuccessful), 09 (unknown
command or protocol error), 10 (temporary failure, in recovery), 11 (failure, no recovery) and
12 (bandwidth deletion request). The value 00 is used for unassigned engines.
values are 01 (no resources available), 02 (channel error), 03 (normal clearing), 04 (bandwidth
addition request), 05 (mode not supported), 06 (rate not supported), 07 (information channel
or frame alignment word framing lost), 08 (delay equalization unsuccessful), 09 (unknown
command or protocol error), 10 (temporary failure, in recovery), 11 (failure, no recovery) and
12 (bandwidth deletion request). The value 00 is used for unassigned engines.
Table 7-2. The IMUX Card Configure Screen of Actions
Action
Function
Refresh
Since IMUX call information is not updated in real time, this command will
refresh the screen with new information.
refresh the screen with new information.
Config
Brings up the Configure screen. See below.
Main
Returns to the main screen.