Honeywell HC900 사용자 설명서
Communications Installation - RS-485 Link to Operator Interface
104
HC900 Hybrid Controller Installation and User Guide
Revision 5
9/03
Setting Up the Controller Network Parameters
See the HC900 Hybrid Control Designer Users Guide, Doc. # 51-52-25-110 or respective HC Designer
Help Files for setting up following network parameters:
Help Files for setting up following network parameters:
•
IP Address, Subnet Mask (optional), Default Gateway IP Address (optional)
•
Network Name (optionally used in Peer Data Exchange)
•
Local Name (optional, user identifier for controller)
•
E-mail Server IP Address (required if e-mail alarms are configured)
ATTENTION
This setup will require the controller to be placed temporarily in the Program mode. After the
new network parameters have been downloaded, the controller will conduct a Cold Start in its
transition to RUN. This will cause an initialization if there is a current configuration in the
controller.
new network parameters have been downloaded, the controller will conduct a Cold Start in its
transition to RUN. This will cause an initialization if there is a current configuration in the
controller.