MGE UPS Systems 66244 사용자 설명서

Network
Management Cards

User Manual

T H E   U N I N T E R R U P T I B L E   P O W E R   P R O V I D E R

Network Management Card

 – User Manual

34003676EN/GA

Page 

13/69

• 

•  Battery operation 

• 

•  Loss of communication with the UPS

• 

•  Battery fault

• 

 (green outlet)

•  Outlet powered – Flashing when an

on/off sequence is in progress 

• 

 (red outlet)

•  Outlet not powered or not protected 

“Communication”: indicates the status of the communication between the card and the UPS
“Power source”: indicates whether the power comes from the utility or from the UPS battery 
“Batteries”: indicates whether the battery is being charged or discharged
“Output load level”: indicates the power percentage used at UPS output
“Master output”: indicates if the UPS output is protected 
“Controlled outlets”: indicates if the controlled outlets (if available) are powered.

Z 

“Bargraph”: Graph showing the remaining battery charge (in percent). 

Z 

“Battery charge level”: Remaining battery charge (in percent). 

Z 

“Remaining backup time”: Estimation of the maximum backup time remaining before UPS shutdown.

This time can be modified by the adjustments on the “Shutdown parameters” page  

Z 

“Last periodical test”: Result of the last automatic battery test carried out by the UPS

Possible values are:

- OK: the test was completed correctly

– NOK: the battery needs to be checked

– Deactivated: the automatic battery test is not validated on the UPS 

The “About your UPS” zone provides information on the UPS and the Network Shutdown Card, in particular,
the model range and software version.

Note: If the UPS is connected by dry contacts, neither picture or name are indicated, the “2 contacts”  title is
displayed and only the following parameters are specified in the UPS status zone: