Multi-Tech Systems 7600 사용자 설명서

The Front Panel’s Setup Menu

 ION 7500 / ION 7600 User’s Guide

Page 32

Chapter 2 - Using The Front Panel 

Using the Front Panel Buttons for Configuration

Use the front panel buttons as follows to adjust the settings:

PROG

Press the 

PROG

 (programming) button to access the Setup Menu. Once in 

programming mode, the 

PROG

 button functions just like an Enter key on a 

computer keyboard. Press the 

PROG

 button to select a highlighted item or accept 

changes, passwords, and trigger resets.

ESC

Press the 

ESC

 (escape) button to return to a higher menu or abort a configuration 

change.

Navigation

Highlight menu items with the vertical (Up/Down) buttons.

Entering numbers: when a digit is highlighted, pressing the Up button increments 
the number by one, and pressing the Down button decreases it. Move the cursor to 
an adjacent digit with the horizontal (Left/Right) buttons.

Softkeys

Press a Softkey button when Softkey options become available (when titles appear 
in the Softkey title bar). Use Softkeys to select the parameters that you want to 
configure from the various sub-menus.

Passwords

All configuration functions in the front panel are password protected. The 
password is set to 0 (zero) in the factory. This password allows you to access the 
Security setup menu and to disable or change the password for a custom value. 
The front panel only prompts you for the meter password before you make your 
first configuration change. 

Setup Mode Timeout

Once the meter has been configured, the front panel automatically exits the Setup 
menu five minutes after the last button press is detected. If the front panel returns 
to data display mode, you must re-enter the Setup menu and provide the valid 
meter password to resume making configuration changes.

Confirming Configuration Changes

The CONFIRM screen appears whenever you attempt to change the meter’s 
settings through the front panel. This allows you to abort an unwanted 
configuration change. The front panel also informs you when an entry is out of 
range. In either case, you must press the 

PROG

 button to return to the setup screen.

WRITING

 

ERROR

 Screen

If the CONFIRM screen does not appear for a valid entry, or the display reports a 
WRITING ERROR, repeat the configuration change. If the problem persists, 
contact Technical Services.