Acer 08P4100 사용자 설명서

NetWare

Manual No. 775079

2-5

3. Choose “Configure disk and storage device drivers” in the Driver 

Options menu.

4. Choose “Select an additional driver” in the Additional Driver Actions 

menu.

NetWare scans for controllers that do not have drivers already loaded.

5. At the “Select a driver” box, press <Ins> to choose to install an 

unlisted driver.

6. Insert the DOS-formatted NT4/NW Drivers Software Kit diskette into 

the diskette drive.

7. Press <F3> to specify the path of the NetWare driver you’re about to 

install.

8. Change the path line to read:

and press <Enter>. NetWare scans for drivers on the floppy diskette in 
the specified path.

9. In the “Select a driver to install” box, select the appropriate driver for 

your controller:

MDAC.HAM | <Controller model number>

10. Select Yes at the confirmation box to install the driver.

11. Press <Enter> to select the default server boot path.

12. Select Yes to save a backup of the old or existing driver.

13. Press <Enter> to continue when you see the message that the old 

driver will be saved.

NetWare copies the file.

14. What you just backed up was the old or existing .DSK or .HAM file. 

Repeat Steps 12 and 13 for the .DDI file.

15. Select No to decline selection of an additional driver to install unless 

you are installing more than one Mylex controller at this time. 

16. Exit INSTALL.NLM by pressing <Esc> three times, then selecting Yes 

at the “Exit Install?” box.

This concludes installation of the driver files needed to run your Mylex Disk 
Array Controller under NetWare 4.2.