Acer 08P4100 사용자 설명서
Installing the Mylex Disk Array Controller as the Primary Windows 2000 Controller
4-6
PCI Disk Array Controller Drivers Manual
4. When prompted for the Manufacturer’s supplied hardware support
disk, insert your Mylex Windows 2000 Drivers Software Kit diskette
into the floppy disk drive and press <Enter>.
into the floppy disk drive and press <Enter>.
You will see a screen with the following information:
You have chosen to configure a SCSI Adapter for use with Windows
2000, using a device support disk provided by an adapter
manufacturer.
2000, using a device support disk provided by an adapter
manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
to return to the previous screen.
5. Use the scroll bar (if available) to locate and select one of the following
devices:
Mylex AcceleRAID 160 Disk Array Controller
1
Mylex AcceleRAID 170 Disk Array Controller
Mylex AcceleRAID 352 Disk Array Controller
Mylex eXtremeRAID 2000 Disk Array Controller
Mylex eXtremeRAID 3000 Disk Array Controller
Mylex AcceleRAID 352 Disk Array Controller
Mylex eXtremeRAID 2000 Disk Array Controller
Mylex eXtremeRAID 3000 Disk Array Controller
6. With the Software Kit diskette still in the floppy disk drive, select your
controller and press <Enter>. The driver will load and the installation
program will ask you if you want to install any additional drivers.
program will ask you if you want to install any additional drivers.
7. If you have drivers to install for other controllers (for example, an
on-board SCSI controller to run other devices such as a CD-ROM
drive, etc.), repeat Step 4 and Step 5. Then when prompted, insert the
manufacturer’s supplied hardware support disk, press <Enter>, and
select the appropriate driver from the list.
drive, etc.), repeat Step 4 and Step 5. Then when prompted, insert the
manufacturer’s supplied hardware support disk, press <Enter>, and
select the appropriate driver from the list.
If you have no other drivers to install, or when you have finished
installing other drivers, simply press <Enter> to continue installation.
installing other drivers, simply press <Enter> to continue installation.
If you installed other drivers from other diskettes, you will be asked to
reinsert those diskettes as well.
reinsert those diskettes as well.
8. Finally, you will be prompted to remove any diskettes and CD-ROMs,
and you will be instructed to press <Enter> to reboot the system.
This concludes Mylex Disk Array Controller driver installation for
Windows 2000 when using eXtremeRAID 2000, eXtremeRAID 3000,
AcceleRAID 160/170LP, AcceleRAID 170, or AcceleRAID 352.
Windows 2000 when using eXtremeRAID 2000, eXtremeRAID 3000,
AcceleRAID 160/170LP, AcceleRAID 170, or AcceleRAID 352.
Please continue with the Microsoft Windows 2000 Installation Procedure.
1. Important: Select this device for the AcceleRAID 170LP also.