Acer 08P4100 사용자 설명서

Creating a Driver Diskette for Solaris

7-2

PCI Disk Array Controller Drivers Manual

Before installing the Mylex Disk Array Controller Drivers for Solaris, 
a Mylex MDAC Supplemental Driver Diskette (MDAC Supplemental 
Diskette) must be created according to the instructions in Appendix A, 
“Creating PCI Driver Installation Diskettes.” 

This diskette will be used in both the primary and secondary installation 
processes and when updating a previously installed driver wherever 
instructed.

You can use the Mylex Supplemental Driver Diskette you just created in the 
previous section in one of two ways:

• To use new drivers to install or upgrade the Solaris operating 

environment on a system with new hardware (primary installation), or

• To add new drivers to support (update) new hardware on an already 

installed booted system (secondary installation).

The steps below describe how to use drivers on the Solaris Device 

Configuration Assistant Diskette

1

 for a Primary Installation to install Solaris 

(Intel Platform Edition) on a new system.

These instructions assume that you are installing Solaris 7 onto a x86 system 
using the Mylex MDAC driver.

Use the appropriate Solaris Device Configuration Assistant Diskette as the 
boot diskette.

1. Insert the Solaris Device Configuration Assistant Diskette into your 

1. The Solaris Device Configuration Assistant Diskette is a boot 

diskette provided by Sun Microsystems.