Acer AcceleRAID 170 사용자 설명서
Manual No. 775064
B-1
Appendix B
AcceleRAID 170
Error Messages
☛
Note
The firmware you are using may have these messages
turned off. However, they are listed here for your
reference.
turned off. However, they are listed here for your
reference.
Start-up Error Messages
The BIOS looks for any initialization message posted by the firmware during
the start-up sequence. If a message is found, one of the following errors
displays on screen and the installation process aborts.
the start-up sequence. If a message is found, one of the following errors
displays on screen and the installation process aborts.
AcceleRAID 170 fatal error--Memory test failed!
AcceleRAID 170 fatal error--Command interface test failed!
AcceleRAID 170 hardware error--Run Diagnostics to pinpoint
error
AcceleRAID 170 firmware checksum error--Reload firmware
Drive Check Error Messages
If the firmware finds a valid controller configuration, but it doesn't match the
SCSI drives currently installed, one or more of the following messages
display. Then, the BIOS prints out the following:
SCSI drives currently installed, one or more of the following messages
display. Then, the BIOS prints out the following:
AcceleRAID 170 Configuration Checksum error--Run
configuration utility!
If the firmware detects that during the last power cycle the system was turned
off abruptly leaving some incomplete write operations, the following
message appears:
off abruptly leaving some incomplete write operations, the following
message appears:
Recovery from mirror race in progress
WARNING: Dead SCSI devices (Channel Target) : x:y
The following messages may also appear:
AcceleRAID 170
cannot recover from Mirror Race!
Some system drives are inconsistent!