ADC DL3XR-SCA100 사용자 설명서
Setting Up System Options
LTPS-UM-8013-03
20
August 30, 2002
D3LX CO and RMT Modules
•
9600 baud
•
No parity
•
8 data bits
•
1 stop bit
•
Hardware flow control to OFF
Figure 11.
Connecting a Maintenance Terminal to the SCU
5
At the maintenance terminal, press
. The Enter User Name field appears.
C
ONNECTING
A
M
AINTENANCE
T
ERMINAL
TO
THE
D3RCAM C
RAFT
P
ORT
1
Locate the D3RCAM in the remote cabinet. The D3RCAM craft port is located on the front of the D3RCAM.
2
Select the cable for use between the craft port and the maintenance terminal with a DB-9 (male) connector at
one end and a maintenance terminal connector at the other end.
one end and a maintenance terminal connector at the other end.
3
Connect one end of the interface cable to the maintenance terminal and the other end to the D3RCAM craft
port as shown in
port as shown in
.
4
Start a terminal emulation program such as Procomm that emulates a VT100 terminal.
The default port configuration for the SCU craft port is CRAFT. Ports 2 and 3 must be configured
for CRAFT before the craft interface may be accessed via these ports.
for CRAFT before the craft interface may be accessed via these ports.
Craft port
Maintenance
terminal
Serial
COM port
Interface cable
LEC
ENTER