Compatible Systems HSSI-10/100 사용자 설명서
Chapter 1 - Network Installation
3
Chapter 1 - Network Installation
HSSI-10/100 RIOP Front Panel
This section of the manual will help you install the HSSI-10/100 RIOP to connect a local
Ethernet and remote corporate network. These connections can be made to other Compatible
Systems routers or routers from other vendors.
Ethernet and remote corporate network. These connections can be made to other Compatible
Systems routers or routers from other vendors.
In summary, the steps for installation are:
1.
After mounting the router or placing on a desktop, make sure it is not connected to
any power source.
any power source.
2.
Connect the router to the Ethernet network.
3.
Connect the router to the CSU/DSU or frame switch.
4.
Power up the CSU/DSU or frame switch.
5.
Connect a management console to the router (optional).
6. Plug in the power cable and power up the router.
Connecting the HSSI-10/100 to the Ethernet
The 10/100 Ethernet interface directly supports 100BaseTx or 10BaseT twisted-pair Ethernet.
To connect the router’s Ethernet interface to twisted-pair Ethernet cabling, you will need an
unshielded twisted-pair station cable that is connected to a 10BaseT-compatible twisted-pair
hub (for a transmit speed of 10 Mbps) or a 100Mbps Fast Ethernet hub (for a transmit speed of
100 Mbps).
To connect the router’s Ethernet interface to twisted-pair Ethernet cabling, you will need an
unshielded twisted-pair station cable that is connected to a 10BaseT-compatible twisted-pair
hub (for a transmit speed of 10 Mbps) or a 100Mbps Fast Ethernet hub (for a transmit speed of
100 Mbps).
v Note: Ethernet cables and cable connectors are not supplied with the HSSI-10/100 RIOP
product. Category 5 cabling is required for 100 BaseT operation. Please contact your reseller
or your Compatible Systems representative for information on obtaining the correct Ethernet
cabling supplies.
product. Category 5 cabling is required for 100 BaseT operation. Please contact your reseller
or your Compatible Systems representative for information on obtaining the correct Ethernet
cabling supplies.
If your twisted-pair hub is already in place, you can connect the router to an active network
without interrupting network activity. Simply plug the twisted-pair cable into the RJ-45
Ethernet connector on the front of the unit.
without interrupting network activity. Simply plug the twisted-pair cable into the RJ-45
Ethernet connector on the front of the unit.
Connecting the HSSI-10/100 to a T3 Line Communications Device
The HSSI-10/100 RIOP is not a line communications device. It must be connected to a
CSU/DSU or frame switch, which is then connected to the wide area transmission line. To
connect the HSSI interface to your line communications device, you will need a standard HSSI
cable. The cable is not supplied; again, you may contact your reseller or your Compatible
Systems representative for information on obtaining the correct cabling supplies
CSU/DSU or frame switch, which is then connected to the wide area transmission line. To
connect the HSSI interface to your line communications device, you will need a standard HSSI
cable. The cable is not supplied; again, you may contact your reseller or your Compatible
Systems representative for information on obtaining the correct cabling supplies
v Note: The HSSI-10/100 RIOP includes loopback features which can be used to check the
functionality of your T3 line. Before attempting to route network traffic, use these features to
check the line’s basic integrity.
functionality of your T3 line. Before attempting to route network traffic, use these features to
check the line’s basic integrity.