Deutsche Telekom 504PC SE 사용자 설명서
6
Mounting and Commissioning
What Does the Eumex 504PC SE Require?
Certain prerequisites must be met for the smooth installation and operation of the
Eumex 504PC SE, the configuration software and the Teledat RVS-COM communica-
tions package:
Eumex 504PC SE, the configuration software and the Teledat RVS-COM communica-
tions package:
• You must have a basic Euro-ISDN connection with a network terminator (NTBA) as
supplied by Deutsche Telekom (DSS 1). The Eumex 504PC SE is not designed to
be operated on any other type of connection and any attempt to do so will lead to
faulty operation.
be operated on any other type of connection and any attempt to do so will lead to
faulty operation.
• Only equipment supplying safety extra low voltage (SELV) and/or complying with
ETS 300 047 may be connected to the Eumex 504PC SE. Equipment operated in
accordance with its purpose complies with this regulation.
accordance with its purpose complies with this regulation.
• In order to be able to use the full range of the Eumex 504PC SE features, you
should only use analogue telephones with DTMF dialling and a flash function (70 -
330 ms).
330 ms).
The minimum system prerequisites for the installation of the Teledat RVS-COM com-
munications software are as follows:
munications software are as follows:
• IBM-compatible PC with hard disk and CD-ROM drive
• CPU speed of 233 MHz or faster
• 64 MB RAM
• Microsoft Windows 98/Me/2000/XP*
• One free USB interface or
• CPU speed of 233 MHz or faster
• 64 MB RAM
• Microsoft Windows 98/Me/2000/XP*
• One free USB interface or
serial port (COM port) RS 232 (V.24).
* Windows 95/NT4 are also supported. However, there is no guarantee that the
complete range of functions provided will be available, as these operating systems
do not support USB. Connect PCs with these operating systems via the serial inter-
face (V.24). This interface must be equipped with a UART 16550 chip enabling a
data throughput of at least 115 kb/s. PCs built in or after 1996 generally have this
chip. Please refer to your PC manual or ask your dealer or the manufacturer of your
PC about this. In addition, the Eumex 504PC SE must already have been installed
in accordance with the diagram in the chapter entitled "Connecting Devices" on
p. 10 ff.
complete range of functions provided will be available, as these operating systems
do not support USB. Connect PCs with these operating systems via the serial inter-
face (V.24). This interface must be equipped with a UART 16550 chip enabling a
data throughput of at least 115 kb/s. PCs built in or after 1996 generally have this
chip. Please refer to your PC manual or ask your dealer or the manufacturer of your
PC about this. In addition, the Eumex 504PC SE must already have been installed
in accordance with the diagram in the chapter entitled "Connecting Devices" on
p. 10 ff.
Please note:
Before you install the Eumex 504PC SE driver software, you must first remove any exist-
ing ISDN card and uninstall any existing CAPI drivers.
Before you install the Eumex 504PC SE driver software, you must first remove any exist-
ing ISDN card and uninstall any existing CAPI drivers.