Deutsche Telekom 504PC SE 사용자 설명서

Mounting and Commissioning

Connect the Eumex 504PC SE to a separate 230 V~ mains circuit. This prevents the

communications system from being affected by possible short circuits in any other
household equipment.
We recommend you to install a surge protector for protection against sudden high
voltages such as those sometimes occurring during thunderstorms. Consult your
electrician or Deutsche Telekom for advice.

Wall Mounting

Tools for Wall Mounting

Choosing a Location for Your Eumex 504PC SE

You can simply place the Eumex 504PC SE on a solid surface, e.g. a table. Please
note that under certain circumstances the rubber pads on the base of the Eumex
504PC SE can leave unseemly marks on furniture.

You will require the following tools for wall mounting:
• 6 mm masonry drill bit (the type of drill bit depends on the type of wall)

• Hammer or percussion drill

• Screwdriver (to fit the screws supplied)

Get the rawlplugs, screws and drilling template (all supplied) ready before you start
mounting the device.

Make sure that there are no pipes, cables or similar objects running through the wall
near the planned drill holes, as these could be damaged.

Use the drilling template supplied and a 6-mm bit to drill holes for the two mounting
screws 94.4 mm apart.

Insert the wall plugs and screw the screws into the wall so that a space of 4 mm
between the head of the screw and the wall remains.

Place the mounting holes in the base of the Eumex 504PC SE over the screws, and
pull downwards slightly.