Motorola 3342 사용자 설명서

279

set pinhole name

name protocol-select { tcp | udp }

Specifies the type of protocol being redirected.

set pinhole name

name external-port-start [ 0 - 49151 ]

Specifies the first por t number in the range being translated.

set pinhole name

name external-port-end [ 0 - 49151 ]

Specifies the last por t number in the range being translated.

set pinhole name

name internal-ip internal-ip

Specifies the IP address of the internal host to which traffic of the specified type should be transferred.

set pinhole name name internal-port [ 0 - 65535 ]

Specifies the por t number your Motorola Netopia® Gateway should use when for warding traffic of the spec-
ified type. Under most circumstances, you would use the same number for the external and internal por t.

PPPoE /PPPoA Settings

You can use the following commands to configure basic settings, por t authentication settings, and peer
authentication settings for PPP inter faces on your Motorola Netopia® Gateway.

Conﬁguring Basic PPP Settings.

☛

NOTE:

For the DSL platform you must identify the vir tual PPP inter face [

vccn], a number from 1 to 8.

set ppp module [vccn] option { on | off }

Enables or disables PPP on the Motorola Netopia® Gateway.

set ppp module [vccn] auto-connect { on | off }

Suppor ts manual mode required for some vendors. The default

on is not normally changed. If auto-connect

is disabled (

off), you must manually start/stop a ppp connection.

set ppp module [vccn] mru

integer

Specifies the Maximum Receive Unit (MRU) for the PPP inter face. The integer argument can be any num-
ber between 128 and 1492 for PPPoE; 1500 other wise.