Motorola 7000 사용자 설명서

Sends an Address Resolution Protocol (ARP) request to match the nnn.nnn.nnn.nnn IP address to an 
Ethernet hardware address.

Clears the configuration settings in a Motorola Netopia® Gateway. If you do not use the optional 

 qual-

ifier, you are prompted to confirm the 

 command.

Removes an SSL cer tificate that has been installed.

Erases the log information stored in flash if persistent logging is enabled.

Puts the command line inter face into Configure mode, which lets you configure your Motorola Netopia® 
Gateway with Config commands. Config commands are described star ting on 

. 

Runs a diagnostic utility to conduct a series of internal checks and loopback tests to verify network connec-
tivity over each inter face on your Motorola Netopia® Gateway. The console displays the results of each test 
as the diagnostic utility runs. If one test is dependent on another, the diagnostic utility indents its entr y in 
the console window. For example, the diagnostic utility indents the Check IP connect to Ethernet (LAN) 
entr y, since that test will not run if the Check Ethernet LAN Connect test fails. 

Each test generates one of the following result codes:

server_address ] [filename] [confirm]

This command installs a file of configuration parameters into the Motorola Netopia® Gateway from a TFTP 
(Trivial File Transfer Protocol) ser ver. The TFTP ser ver must be accessible on your Ethernet network.

PASS

The test was successful.

FAIL

The test was unsuccessful.

SKIPPED

The test was skipped because a test on which it depended failed, or 
because the test did not apply to your particular setup or model.

PENDING

The test timed out without producing a result. Try running the test again.