Motorola 7000 사용자 설명서

A static route identifies a manually configured pathway to a remote network. Unlike dynamic routes, which 
are acquired and confirmed periodically from other routers, static routes do not time out. Consequently, 
static routes are useful when working with PPP, since an intermittent PPP link may make maintenance of 
dynamic routes problematic.

When you click the 

 link, the 

IP Static Routes page appears.

You can configure as many as 32 static IP routes for the Gateway. To add a static route, click the 

 but-

ton.

The 

IP Static Route Entry page appears.

•

Destination Network: Enter the IP address of the static route. It may not be 0.0.0.0.

•

Netmask: Enter the subnet mask for the IP network at the other end of the static route. The subnet 
mask associated with the destination network must represent the same network class (A, B, or C) or a 
lower class (such as a class C subnet mask or class B network number) to be valid.

•

Interface Type: Choose PPP (vcc1) – depending on the inter face; typically vcc1 for DSL – or IP Address 
from the pull-down menu to specify whether the static route is accessible through PPP or IP address.

•

Gateway: Enter the IP address of the gateway for the static route. The default gateway must be located 
on a network connected to your Motorola Netopia® Gateway configured inter face.

•

Metric: Specifies the hop count for the static route. Enter a number from 1 to 15 to indicate the number 
of routes (actual or best guess) a packet must traverse to reach the remote network. Some metric or a 
value of 1 will be used to indicate:
• The remote network is one router away and the static route is the best way to 
   reach it.
• The remote network is more than one router away but the static route should not 
   be replaced by a dynamic route, even if the dynamic route is more efficient.