Netgear WNHDE111 5GHz 사용자 설명서

2-6

Easy Secure Wireless Setup

Wireless-N AccessPoint/Bridges, if purchased as a kit, are pre-configured to securely connect to 
each other automatically, according to the instructions above. To add a second WNHDE111, 
simply use the WPS (Wi-Fi Protected Setup) push button.

1. Make sure the WNHDE111 you are adding is set to Auto or Bridge mode but not set to AP 

mode, and place it near the devices you will connect to it.

2. Connect the power adapter. The power light should blink quickly in groups of 3 (if the power 

light is off, press the power light on/off switch on the back panel to turn it on).

3. On the new WNHDE111, press the WPS button; its WPS light will blink.Within 2 minutes, 

press the WPS button on the existing Wireless-N Bridge which is operating in AP mode. Its 
WPS light will start to blink.

After 1-2 minutes the new unit in Bridge mode should be associated with the existing unit in 
AP mode. The WPS light for the Bridge mode unit will turn off. On the AP mode unit, the 
WPS light will be on solid for about 6 minutes, then turn off. The power lights on both units 
will be steadily on.