Netgear WGR614v7 사용자 설명서

3-10

Configuring the Internet and Wireless Settings

•

Automatic Key Generation (Passphrase): Enter a word or group of printable 
characters in the Passphrase box and click the Generate button to automatically 
configure the WEP Key(s). If encryption strength is set to 64 bit, then each of the four 
key boxes will automatically be populated with key values. If encryption strength is 
set to 128 bit, then only the selected WEP key box will automatically be populated 
with key values. 

•

Manual Entry Mode: Select which of the four keys will be used and enter the 
matching WEP key information for your network in the selected key box.

 

For 64 bit WEP: Enter ten hexadecimal digits (any combination of 0-9, A-F).

 

For 128 bit WEP: Enter twenty-six hexadecimal digits (any combination of 0-9, A-F). 

–

WPA-PSK (Wi-Fi Protected Access Pre-Shared Key): use WPA-PSK standard 
encryption

•

Security Encryption (WPA-PSK): Enter a word or group of printable characters in 
the Passphrase box. The Passphrase must be 8 to 63 characters in length.

When you first receive your WGR614v7, the default factory settings are shown below. You can 
restore these defaults with the Factory Default Restore button on the rear panel. After you install 
the wireless router, use the procedures below to customize any of the settings to better meet your 
networking needs.

Wireless Access Point

Wireless Access List (MAC Filtering)

SSID broadcast 

SSID 

11b/g RF Channel

Mode

Authentication Type

WEP