Netgear WNR3500L 사용자 설명서

Troubleshooting

8-3

After you turn on power to the router, the following sequence of events should occur:

1. When power is first applied, verify that the Power light 

is on.

2. After approximately 1 minute, verify that:

a. The Power light is solid green.

b. The Internet light is on if the Internet port is connected.

A numbered LAN port light is on for any local port that is connected to a computer. This 
indicates that a link has been established to the connected device.

If any of the above conditions does not occur, see the following table.

Power light is off.

Check the following:
• Make sure that the power cord is properly connected to your router 

and that the power adapter is properly connected to a functioning 
power outlet.

• Check that you are using the power adapter supplied by NETGEAR 

for this product.

If the error persists, you have a hardware problem and should contact 
technical support.

Power light stays amber.

When the router is turned on, the Power light turns amber for about 60 
seconds and then turns green. If the light does not turn green, the 
router has a problem.
If the Power light is still amber 2 minutes after turning on power to the 
router:
1. Turn the power off and back on to see if the router recovers.
2. Clear the router’s configuration to factory defaults. This will set the 

router’s IP address to www.routerlogin.net. This procedure is 
explained in 

.

If the error persists, you might have a hardware problem and should 
contact technical support.