Netgear WNDR3400v3 사용자 설명서

If all LEDs are still lit 1 minute after power-up:

Cycle the power to see if the router recovers.

Press and hold the Restore Factory Settings button to return the router to its factory 
settings. See 

106.

If the error persists, you might have a hardware problem and should contact technical 
support at 

www.netgear.com/support

.

If either the Ethernet port LEDs or the Internet LED does not light when the Ethernet 
connection is made, check the following:

Make sure that the Ethernet cable connections are secure at the router and at the modem 
or computer.

Make sure that power is turned on to the connected modem or computer.

Be sure that you are using the correct cable:

When connecting the router’s Internet port to a cable or DSL modem, use the cable that 
was supplied with the cable or DSL modem. This cable could be a standard 
straight-through Ethernet cable or an Ethernet crossover cable.

If the Wireless LEDs stay off, check to see if the Wireless On/Off button on the router has 
been pressed. This button turns the wireless radios in the router on and off. The Wireless 
LEDs are lit when the wireless radio is turned on.

If after you use the WPS function the button blinks green, check the following:

Make sure that you are using the button and not the router’s built-in registrar.

Check that PIN verification has succeeded for the wireless device you are adding to the 
wireless network.

Make sure that you have not pressed the WPS button on the side of the router after 
disabling the WPS feature (you logged in to the router and disabled this previously).

Check that the router is not in the temporary AP setup locked state (if you are using the 
wireless repeater function).

If you are unable to log in to the router from a computer on your local network, check the 
following: