Netgear R4500 전단
Ethernet cable ( ) to your modem,
Step 2:
Connect one end of the yellow
and the other end to the Internet port
on your router.
on your router.
Step 6:
Open a browser.
Step 4:
Step 3:
Plug in, then turn on your modem.
Wait approximately 2 minutes
until your modem turns on.
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
first remove and reinsert the battery
before connecting your
modem to power.
N900 Wireless Router
(not included)
Laptop or Desktop
Computer
N900 Wireless Router
Package Contents
N900 Wireless Dual Band Gigabit Router
R4500
Installation Guide
Power adapter
Ethernet cable
Power On/Off
(with stand attached)
Connect the power adapter to the
router, then plug it into an outlet.
Wait for the 2.4 GHz LED ( )
to turn on.
router, then plug it into an outlet.
Wait for the 2.4 GHz LED ( )
to turn on.
If none of the LEDs turn on, make sure the
Power On/Off button is in the ON position
(pushed in).
Power On/Off button is in the ON position
(pushed in).
2.4
GHz
Step 1:
Unplug the power
to turn off your modem.
to turn off your modem.
Step 5:
Connect your computer
to the router ( ).
to the router ( ).
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
a wired connection as shown in this diagram.
Optionally, connect wirelessly by using
the preset wireless security settings
located on the bottom label.
the preset wireless security settings
located on the bottom label.
Power cord
Modem
DSL
or Cable
Internet
Power On/Off
If the web page does not
display, close and re-open
the browser, then enter
display, close and re-open
the browser, then enter
in the address bar, or
check the “Troubleshooting”
section on the back of
this installation guide.
check the “Troubleshooting”
section on the back of
this installation guide.
http://www.routerlogin.net