Netgear JNR1010v2 사용자 설명서
Supplemental Information
90
JNR1010v2 N150 Wireless Router
Factory Settings
You can return the router to its factory settings. Use the end of a paper clip or some other
similar object to press and hold the WPS/Reset button on the back panel of the router for at
least four seconds. The router resets, and returns to the factory settings that are shown in the
following table.
similar object to press and hold the WPS/Reset button on the back panel of the router for at
least four seconds. The router resets, and returns to the factory settings that are shown in the
following table.
Table 4. JNR1010v2 router factory default settings
Feature
Default Behavior
Router login
User login URL
User name (case-sensitive)
admin
Login password (case-sensitive)
password
Internet
connection
connection
WAN MAC address
Use default hardware address
WAN MTU size
1500
Port speed
AutoSensing
Local area
network (LAN)
network (LAN)
LAN IP
192.168.1.1
Subnet mask
255.255.255.0
DHCP server
Enabled
DHCP range
192.168.1.2 to 192.168.1.254
Time zone
United States is Pacific Time; otherwise, varies by region
Time zone adjusted for daylight
saving time
saving time
Disabled
Wireless
Wireless communication
Enabled
SSID name
Preset. For information, see the router label. (For a
description of the router label, see
description of the router label, see
Network key (password)
Broadcast SSID
Enabled
Transmission speed
Auto
Note:
Maximum wireless signal rate derived from IEEE
Standard 802.11 specifications. Actual throughput varies.
Network conditions and environmental factors, including
volume of network traffic, building materials and
construction, and network overhead lower actual data
throughput rate.
Network conditions and environmental factors, including
volume of network traffic, building materials and
construction, and network overhead lower actual data
throughput rate.
Country/region
United States in the US; otherwise, varies by region
RF channel
Auto
Operating mode
Up to 150 Mbps